Products needed:
- Clear Embossing powder
- White Cardstock
- Versamark (watermark) Ink
- Texture (print) stamp
- Dauber ( twinkling h2o's)
Step 1
Ink your stamp and stamp the image on the white cardstock.
Step 2
- Sprinkle Clear Embossing powder over the top of the wet stamped image
- Shack off excess
- Place the excess back into packaging
Step 3
- Heat the embossing powder with a heat gun or from the heat above a toaster
Step 4
- Choose what colour of dauber you would like
- Shake your dauber to allow the shimmer to evenly go through the paint
- lightly dab onto your embossed cardstock
- Cover the entire card or use another colour if you wish.
FINISHED SAMPLE.....
*************************************************************************************
LESSON 2
Products needed:
- Clear Embossing powder
- White Cardstock
- Versamark (watermark) Ink
- Textures around your home. eg, flowers, felt, mesh die cuts etc.
- re-Inker
- Container with a small amount of water
- small spounge
Step 1
- Using materials out of your home or scrap area
- Place onto white cardstock
- I have used some fancy pants felt and platers mesh
- Cut where desired
Press down the mesh over the top to make sure it is firm around any edges
Step 3
Using your watermark pad
Ink over the areas you want
Step 4
Remove the templates you have used
Step 5
- Sprinkle with clear embossing powder
- Heat using a heat gun or above a toaster
Step 6
- Put a small amount of water into a small container
- Place a drop of a water based reinker
- Swish the ink around to make it very watery
Step 7
- Using a spounge
- place into the container
- and paint like a paint brush over your card
- Where ever the embossing powder was will remain white
Step 8
- Cover the entier area of your card
- Repeat the ink to make some areas darker
FINISHED SAMPLE....
I have more step by step resist techniques i will give you next week.
thanks for looking
enjoy
luv tanXx
1 comment:
Very nicely shown! Thank you, Tan :D
Post a Comment